Tuesday, June 29, 2010

Charming Books for charming cooks! A Book Cover Tutorial.

Do you remove the sleeves on your books so that they don't get ruined?  Then are you worried about your books getting ruined?  The covers of my cookbooks are ALWAYS getting dirty and I hate that, but I also hate the sleeves getting dirty.  You just cannot win with me! ;)

Remember making brown paper book covers in school?  They were always so...well brown.  My husband had his cook books covered in those when we met (he is much neater than I am).  So, I decided to put together a removable and washable book cover, like those brown bag covers, but one that is much less drab and that also shows off my love of sewing...and charm packs! 

Want one too?  Here's how to make one, and please be sure to have fun! :)


  • Book to be covered
  • Tape measure
  • Charm Pack (5" squares) or other squared pieces of fabrics 
  • Backing fabric (needs to measure 10" wider than book width and 2 -1/2" longer than the book length) 
  • Thread 
  • Pins 

1.  Measure the complete width of the book to be covered by starting at the the back left side and wrapping the tape measure around the book. 

2.  Measure the length of the book.

3.  Determine the number of charm squares you will need based on your measurements and then add 2 more charm squares to the width of the book and 1 more charm square to the length. 

The book in the picture measured 17-1/2" in width and 9-1/2" in length.  

So I needed 4 squares to equal the initial width plus 2 squares for the end total.  

And then I needed 2 squares to equal the length of the book plus 1 square for the end total.

My final amount was 6 charm squares across by 3 charm squares down for a total of 18 squares.

4.  Sew all your squares together with 1/4" seam allowance.  The easiest way to do this is to sew the greater number of squares together into rows and then sew the rows together, lining up the seams to create a patchwork cover.   

5.  The sewn together squares should be as close as possible to 10" wider than the book measurement.

And the length should be as close as possible to 5" longer than the book measurement.

6.  Measure 2-1/4" in along the widthwise edge of each side and draw a line. 

7.  Fold the widthwise edge in to meet the line just drawn and press. 

8. Lay the patchwork top on the backing fabric, right sides together.  

If you have not cut the backing fabric to fit the measurements yet, then cut it to match the patchwork top.  

Pin and sew the just folded patchwork top along both widthwise edges to the backing fabric with a 1/4" seam allowance.  

Sew one lengthwise edge from top to bottom with a 5/8" seam allowance.  Sew the opposite lengthwise edge from top to middle, then stop and leave a 2-3" turning gap unsewn, then sew from the end of the gap to the bottom of the edge.  

9.  Turn book cover right side out through turning gap.  Push out all corners and press.  Sew the lengthwise edges with a 1/8" edge stitch.

10.  Place book on top of the top of the cover, center book on the very center of the cover both widthwise and lengthwise.  

Fold cover over the book so that that all edges meet. 

10.  Fold the top edge under the book cover and pin at the lengthwise edge creating a book "sleeve". 

Carefully remove the cover from the book keeping the "sleeve" and pins in place.  Add pins along the lengthwise edge.

11.  Sew along the edge creating a sleeve.  This is a little tricky, you want to sew a straight line along the widthwise edge in the exact place where you pinned the "sleeve" while it was on the book.  You can wing it or draw a line after pinning the rest of the sleeve edge down.  

I'll be honest...I winged it and it turned out fine.  I lined up the pin with the stitch line on my sewing foot and looked at the seam guide to determine the seam allowance, then I just sewed the edges with that seam allowance.    

12.  Put sleeve just created on the top of the book and wrap cover around book again. Create "sleeve" on the opposite side following the previous "sleeve" steps.

 12.  Turn "sleeves" right side out.  Push out corners and sides and press. 

13.  Sew the edges in between the sleeves with a decorative stitch, securing the edges together.  

Now put the cover on the book just like you would with a paper bag cover, one sleeve at a time. Close the book and tada!  A beautiful cover that can be removed and washed!  Now I am off to cover ALL my cookbooks! How about you? 

Tuesday, June 22, 2010

Flying Fat Quarter Fun!

Our little man is about the age where he would enjoy a cape!  However as a slightly neurotic mom, I've never been willing to get a cape, because I worry about the choking risk.  That's when I came up with my fat quarter cape.

The first cape I created with the basketball fat quarter, but it didn't look quite as good as I wanted it to, so I made a second with some measurement modifications. 

I had two pieces of this super cute Cars print and sewing them together made one fat quarter (18" x 22"). And then I ended up with a cape, the little man and I really like it!


1.  On each shorter side of the fat quarter measure 6" in, and on the longer side measure 7" down. Create one line from the measurements and slice at an angle removing the corners.   This makes the top of the cape.

2.  Measure 3" up from the bottom of the fat quarter and cut it off.

3.  Cut the 3" x 18" strip in half so you have two 3" x 9" pieces.  These will be the straps.

4.  Fold the one shorter edge of each strip over 1/2".  Then fold in half length wise, wrong sides together.  Press.  Sew along the two raw edges with a 1/4" seam allowance, leaving the folded edge alone and the edge that you folded over previously open. 

5.  Turn the pieces right side out and edge stitch along all four sides with 1/8" seam allowance.  Sew down the middle as well, for more stability.

All sides need to be hemmed using a double fold hem:

1.  Fold in 1/2 the amount of the total hem. 
2. Press.
3.  Fold again for 1/2 the amount of the total hem, placing the raw edge on the inside.  Press.

**Please Note: In my directions, when I say to create a 1/4" double fold hem, I want you to do a 1/4" fold and then another 1/4" fold.**  

6.  Fold over top angled sides for a 1/4" double fold hem.  Edge stitch, 1/8" from the folded edge.  Repeat with the top for a 1/2" double fold hem.  

7.  Hem the sides with a 1" double fold hem.  Then finish by hemming the bottom with a 1/2" double fold hem. 

8.  Take shorter sides of straps and line up with the top corners of the cape.  Sew with a 1/4" seam allowance.

9.  Line up bottom of straps with the bottom corner of the angled sides, running the straps parallel with the angled edges.  Sew at 1/4 seam allowance. 

All Finished!  



So Much FUN!  

 My Little Super Hero!
 Strikes a heroic pose and no choking worries! 

Related Posts Plugin for WordPress, Blogger...